Materials Science and Manufacturing Engineering Miscellaneous


Materials Science and Manufacturing Engineering Miscellaneous

Materials Science and Manufacturing Engineering

  1. The flanks of teeth of rack-type gear cutter used for cutting involute gear profiles are









  1. View Hint View Answer Discuss in Forum

    Involute

    Correct Option: C

    Involute


  1. The drawing shows a machined shaft. The purpose of providing rounded grooves at M and N is to









  1. View Hint View Answer Discuss in Forum

    NA

    Correct Option: A

    NA



  1. Which one of the following is not a synthetic abrasive material?









  1. View Hint View Answer Discuss in Forum

    Titanium Nitride.

    Correct Option: C

    Titanium Nitride.


Direction: Data for a plain milling operation are given below. Length of workpiece 200 mm Cutter diameter 100 mm No. of teeth 4 Cutter speed 100 rpm Feed 200 mm/min Depth of cut 2 mm Total clearance (entry and exit) 5 mm

  1. Machining time for one single pass (in seconds) is









  1. View Hint View Answer Discuss in Forum

    AP =
    1
    (D - √D² - d²)
    2

    = √d(D - d)
    = √2(100 - 2) = 14 mm
    Time/cut =
    L
    =
    200 + 5 + 14
    × 60
    fm200

    = 65.7 s ≈ 66 s

    Correct Option: B

    AP =
    1
    (D - √D² - d²)
    2

    = √d(D - d)
    = √2(100 - 2) = 14 mm
    Time/cut =
    L
    =
    200 + 5 + 14
    × 60
    fm200

    = 65.7 s ≈ 66 s



  1. Mean up-deformed chip thickness (in microns) is









  1. View Hint View Answer Discuss in Forum

    tavg =
    tmax + tmin
    2


    = 0.0707 mm = 71 mm

    Correct Option: C

    tavg =
    tmax + tmin
    2


    = 0.0707 mm = 71 mm