Academic Resource
Aptitude
Data Interpretation
Verbal Reasoning
Non Verbal Reasoning
Verbal Ability
Programming
General Knowledge
Puzzle
Engineering
Computer Engineering
Electronics and Communication
Electrical Engineering
Mechanical Engineering
Civil Engineering
Biotechnology
Architecture & Planning
Online Test
Aptitude Test
Data Interpretation Test
Verbal Reasoning Test
Non Verbal Reasoning Test
Verbal Ability Test
Exams
More
Full Forms
Home
»
Materials Science and Manufacturing Engineering
»
Materials Science and Manufacturing Engineering Miscellaneous
» Question
Materials Science and Manufacturing Engineering Miscellaneous
Easy Questions
Moderate Questions
Difficult Questions
Materials Science and Manufacturing Engineering
Materials Science and Manufacturing Engineering Miscellaneous
A sine bar has a length of 250 mm, each roller has a diameter of 20 mm, during taper angle measurement of a component, the height from the surface plate to the centre of a roller is 100 mm. The calculated taper angle (in degrees) is
21.1
22.8
23.6
68.9
Correct Option:
A
θ =
90
250
θ = 21.1°
Previous Question
Next Question
Your comments will be displayed only after manual approval.
Post your Comment
